Klarstein 10030930 Manual De Instrucciones página 43

Troubleshooting
Reviewing the charts on the following pages may make you be free of calling for service:
Problem Possible causes
Dishwasher Fuse blown, or the circuit breaker
doesn't run acted
Power supply is not turned on
Water pressure is low
Drain pump Overflow
doesn't stop
Noise Some audible sounds are normal
Utensils are not secure in the
baskets/ something has dropped
into basket
Motor hums
Suds in Improper detergent
the tub
Spilled rinse agent
Stained tub Detergent with
interior colorant was used
Dishes and Improper program
flatware Improper basket loading
not clean
Spots and 1 Extremely hard water
filming on 2 Low temperature
glasses and 3 Overloading
flatware 4 Improper loading
5 Damp powder detergent
6 Empty rinse agentr
7 Incorrect dosage
Cloudiness Combination of soft water and too
on glassware much detergent
What to do
Replace fuse or reset circuit breaker. Remove any other appli-
ances sharing the same circuit with the dishwasher.
Make sure the dishwasher is turned on and the door is closed
securely. Make sure the power cord is properly plugged into
the wall socket.
Check that the water supply is connected properly and the
water is turned on.
The system is designed to detect an overflow. When it does, it
shuts off the circulation pump and turns on the drain pump.
Sound from detergent cup opening.
To ensure everything is secured in the dishwasher.
If you do not use it often, remember to set it to fill and pump
out every week, which will help keep the seal moist.
Use only the special dishwasher detergent to avoid
suds. If this occurs, open the dishwasher and let suds
evaporate. Add 1 gallon of cold water to the tub. Close
and latch the dishwasher, then start the „pre-rinse" wash
cycle to drain out the water... Repeat if necessary.
Always wipe up rinse agent spills immediately.
Make sure that the detergent is the one without colorant
Select a stronger programme
Make sure that the action of the detergent dispenser and spray
arms are not blocked by large dishware
1 Take out all metal utensils out of the dishwasher.
2 Do not add detergent.
3 Choose the longest cycle.
4 Start the dishwasher and allow it to run for about 18 to 22
minutes, then it will be in the main wash.
5 Open the door to pour 2 cups of white vinegar into the
bottom of the dishwasher.
6 Close the door and let the dishwasher complete the cycle. If
the vinegar does not work use citric acid crystals instead.
Use less detergent if you have soft water and select a
shortest cycle to wash the glassware
43