EN
3.2 Adjustment of the handle bar
Keep both release buttons pressed (fig . 4, no . 1) and then turn the handle bar in
the desired position (fig . 5, a–c) .
3.3 Folding the chassis
The handle bar must be in lowest position during this action (fig . 5, a) . Pull the
folding belt inside the seat upwards (fig . 6, no . 1 ) until the chassis collapses (fig . 7) .
Then close the locking hook (fig . 7, no . 1) .
3.4 Attaching and removing the sun canopy
Press on each side the clip of sun canopy above the frame (fig . 8, no . 1) and then
turn it below on the frame (fig . 8, no . 2) . Afterwards close the two snap fastener
(fig . 9, no . 3) at each side .
If you want to remove the sun canopy proceed like decribed above in reverse
manner .
3.5 Adjustment of the sun canopy
Height-adjustment stepless by moving up and down (fig . 10, a–b), opening and
closing (fig . 11, a–b–c–d) .
3.6 Removing and attaching the front wheels
To remove the front wheels at each side push the button at the front wheel hol-
der (fig . 12, no . 1) and pull out the wheel set simultaneously (fig . 12, no . 2) .
To attach the front wheels push the vertical axle in the hole of the respective
front wheel holder at each side of the frame unti it locks . Check by hand pull tests
whether both front wheels are locked securely to the frame .
20