Preparing The Machine - Stiga 1503 Manual De Instrucciones

2. ASSEMBLY AND DISASSEMBLY OF ACCESSORIES
WARNING!
Position the machine and
accessory on a flat sturdy surface, making
sure there is enough space to allow for
easy manoeuvring and assembly in safe
conditions. Always use protective gloves
and pay attention to avoid performing
operations that can cause accidents.
WARNING!
Always perform the opera-
tion with the engine switched off and cold
and after removing the ignition key.
WARNING!
Never allow other persons
to sit on the machine or approach it when
assembling and disassembling the acces-
sory.

2.1 PREPARING THE MACHINE

Unscrew the two knobs (1) and remove the front
bumper (2).
1
2
2.2 CONNECTION OF THE ACCESSORIES
TO THE INTERFACE
Lifting system without
Power Take-Off (PTO)
– Release the lifting lever (3) to lower the
two interface ( 3.1) tubes (4).
– Approach the two arms (5) on the acces-
sory to the two tubes (4) on the interface;
if the accessory is fitted with a land height
adjustment system, adjust it so that the
arms (5) are aligned with the tubes (4).
1
5
– Push the accessory and move the ma-
chine forward until the arms are fully in-
serted in the tubes. If you encounter prob-
lems during this procedure, apply some
grease to the tubes and move the lifting
lever (3) slightly to ease insertion of the
arms.
– Fully tighten the two knobs (1).
Lifting system with
Power Take-Off (PTO)
– Release the lifting lever (3) to lower the
two interface (
– Lower the belt guide (11) on the lower
section of the machine and turn it to the
1
right to permit clear access to the pul-
ley (12).
12
– Approach the two arms (5) of the acces-
sory to the two tubes (4) of the interface;
if the accessory is fitted with a land height
adjustment system, adjust it so that the
arms (5) are aligned with the tubes (4).
4
5
3.1) tubes (4).
11
4 1
EN 3