Installation; Mower Deck Removal - Briggs & Stratton 800X Manual Del Operador

Tabla de contenido

Installation

Mower Deck Removal Procedure
1. Park the machine on a smooth, level surface such
as a concrete floor. Engage the parking brake,
disengage the PTO, and turn off the ignition key.
2. Turn the ignition key to the RUN position and push
the mower deck lift actuator switch forward (away
from the operator's position) to extend the actuator
until you hear a ratcheting noise.
3. Move the cutting height adjustment pin to the
lowest cutting position.
4. Remove the pins with lanyards (B, Figure 7) from
the attachment lift arms (A).
5. Retract the actuator completely by pulling the
mower deck lift actuator switch backwards (towards
the operator's position).
6. Disconnect the two (2) spring links (C, Figure 7)
from the tractor connection point (F).
7. Extend the actuator until the front wheels contact
the ground.
8. Reinstall the pins with lanyards through the rear
hole (G) of the attachment latches (D).
9. Extend the actuator until the load is removed from
the actuator. Turn the ignition key to the OFF
position.
10. Raise the seat and disconnect the actuator wire
harness (A, Figure 8) on the right side of the
machine by rotating the connector dial (B) and
pulling apart.
11. Pull the mower deck end of the actuator wire
harness from the tractor.
12. Disconnect the rear of the actuator (A, Figure 10)
from the tractor by removing the pin with lanyard
(B).
13. Locate the drive shaft (A, Figure 9) under the
machine and disconnect it by pulling the drive shaft
collar (B) toward the universal joint.
14. Pull the deck attachment lever (E, Figure 7) up
and back.
15. Back the tractor away from the mower deck.
Figure 9. Drive Shaft
A. Drive Shaft Universal Joint
B. Drive Shaft Coupler
10
A
B
A
B
C
F
G
Figure 7. Attachment Lift Arms
A. Attachment Lift Arms
B. Pin with Lanyard
C. Spring Links
D. Attachment Latches
E. Deck Attachment Lever
F. Tractor Connection Point
G. Attachment Latch in Raised Position
A
B
Figure 8. Actuator Wire Harness
A. Actuator Wire Harness
B. Connector Dial
Figure 10. Actuator
A. Actuator
B. Pin with Lanyard
ferrismowers.com | snapperpro.com
D
E
B
A
Tabla de contenido
loading

Este manual también es adecuado para:

56003845600836

Tabla de contenido