Dyna-Glo DGB730SNB Manual De Instrucciones página 23

OPERATING INSTRUCTIONS
Lighting Instructions (For all burners, including side burner and rotisserie burner)
Beforefirstuse:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
tocleanyourgrillwithheat.Todothis,operatethegrillforapproximately15minuteswiththelid
closed and the control knob in the highest position. This will clean the internal parts by burning off any
residue and odor from the manufacturing process.
Important: If your grill is equipped with a rotisserie burner, only that burner should be used for
cooking when the rotisserie is mounted and in operation. The main burners on the grill must be turned
OFF when the rotisserie burner is in use.
Important: DO NOT use the rotisserie burner and the main burner at the same time while using the
rotisserie. DO NOT use side burners and the rotisserie simultaneously.
DO NOT lean over grill when lighting. Read instructions before lighting.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF the
cylinder valve and then TURN OFF the control knobs.
Read instructions before lighting.
1. Check that the control knobs are in the O OFF position.
2. Open lid during lighting.
3. Open valve at tank fully by turning
4. Push igniter down 3 to 4 seconds while turning the desired control knob to the
burner should ignite.
If ignition of any burner does not take place within 5 seconds, immediately turn the control knob to
the O OFF position. Wait 5 minutes and repeat step 4 above or refer to match lighting instructions in
manual.
5. Repeat Step 4 above to ignite all other burners.
WARNING
CAUTION
counterclockwise.
23
high position. The