Filling The Water Tank - H.Koenig STM10 Manual De Utilización

Frame
Brush frame

FILLING THE WATER TANK

1 . Place the steamer on its base on a stable surface.
2 . Hold the handle to stabilize and pull out the removable water tank with the other hand. (C)
3 . Gently pull out the rubber water tank cover at the top of the tank. (D)
TIP: Using distilled, purified, or filtered water is highly recommended and will reduce mineral buildup. Do
not use oils, perfumes, or scented additives.
4 . Using a clean measuring cup, pour water into opening until water reaches the "MAX" level mark on the
top of the tank. ( E) do not overfill . Close the rubber cover securely.
5 . Dry off any excess water from the tank. Push water tank back into the steamer base click into place.
6 . To refill at any time during use, turn steamer off by pressing the power button until the blue indicator
light is off, unplug from outlet, and follow the above procedure.
Tie: After feiling alo to reheat for 45 seconds and then prime pump by holding steam, trigger until steam
forms.
USING THE HANDHELD STEAMER
1 . Read the manufacturers fabric label to make sure the fabrics are suitable for steaming.
▪ If you see "do not iron" or this icon
the delicate fabric frame and make sure to test on an inconspicuous area prior to steaming the entire
garment.
▪ If you see "do not steam" or this icon
2 . Refer to the "Attaching Frames" section for determining whether to use a frame. Attach or remove
frames while the steamer and frames are cool.
Usage
Garment Care Label: For any garments that call for medium to high
heat and allow for use of steam.
Tip:Frame helps remove lint, hair, and animal fur.
C
, do not press the plate against the garment. Instead, attach
, do not steam the garment.
D
E