Placing In Service - Solo 405 US Manual Del Usario

The following symbols are used in these operating
instructions and on the device itself:
Caution
Refer to the operating instructions
Wear protective clothing
Wear protective gloves
Wear face protection
A breathing mask should be worn when
using poisonous chemicals
Maintain a minimum distance of 15
metres bystanders
Safety precautions and general
instructions
Compliance with this safety manual is a
•
prerequisite for proper operation of the sprayer.
The pressure sprayer must be checked before
•
each use.
This pressure sprayer is suitable for applying
•
approved liquid plant protection, insecticides,
and weed killing substances, as well as liquid
fertilizers that are available from authorized
dealers. We recommend using only plant
protection substances that are approved by the
U.S. EPA (Environmental Protection Agency).
The sprayer must be cleaned when changing the
•
spray substance. This avoids possible chemical
reactions.
Do not use liquids over 104°F.
•
Due to bodily hazard, only the abovementioned
•
liquid substances may be applied with this
sprayer. Disinfectants and impregnation
substances may not be used.
Never leave the filled and/or pressurized
•
pressure sprayer unattended for longer periods.
For safety reasons, children, young people
•
under the age of 16, and persons who are not
familiar with these operating instructions, may
not use this pressure sprayer.
The pressure sprayer must be kept out of the
•
reach of children.
The sprayer owner is responsible relative to use
•
by third persons.
The pressure sprayer must be de-pressurized
•
before disassembly of any component, and
before opening the pump, by pulling on the
pressure relief valve (Fig. 3)! Before pulling on
the pressure relief valve, the sprayer must always
be in an upright position. Attention: keep the
sprayer away from your face!
- ENGLISH –
Do not expose the pressure sprayer to high
• temperatures.
For sprayer malfunctions of any kind, such as:
leaks at the tank, spray pipe and tubing,
•
signs of damage, cracks, etc.,
•
other irregularities,
•
pressure relief valve not working correctly,
•
the sprayer must not be used until it is checked by
a qualified person.
The manufacturer was not aware of any harmful
effects on the product materials caused by plant
protection substances at the time the product was
manufactured.
Firmly screw the spray tube with O-Ring (16x3
mm) onto the shut-off valve by fastening the
threaded collar (Fig. 1, Pos.1) on straight and firmly.
Tighten it by hand – do not use excessive force or
any tools to fasten the collar!
Fig. 2: When your work is completed, the spray
tube should be stored in the storage clamp on the
pump handle.
The pressure sprayer can also be carried by the
pump handle, if the pump handle is pressed down
completely, and it is turned to the right and clicked
into position.
The pressure sprayer must be de-pressurized
before disassembling any component, and before
opening the pump, by pulling on the pressure relief
valve (Fig. 3)! Before pulling on the pressure relief
valve the sprayer must always be in an upright
position.
The pump must be removed to fill the the tank with
liquid. To do this, push the pump handle down and
turn it to the left (counterclockwise) until the handle
clicks into position.
Fig. 4: Unscrew pump by turning it counter
clockwise. Do not use any tools!
When filling the tank with liquid, do not fill above
the maximum fill mark.
Model 405 US: 1 US.liq.gal
Model 406 US: 2 US.liq.gal
Always follow the safety precautions and use the
correct chemical mixture ratio according to the
instructions provided by the manufacturer of the
spray substance!
Thoroughly mix the liquid, insert and tighten the
pump securely by turning clockwise. Secure the
pump handle by turning the pump handle clockwise
until it clicks into position.
Assembly

Placing in service