Wiring - Jensen VM8013HD Instrucciones De La Instalación Y De La Operación

VM8013HD

WIRING

NOTE: The amplifier in this radio is only designed for use with four
speakers. Never combine (bridge) outputs for use with two
speakers. Never ground negative speaker leads to chassis ground.
SAT BUS
JXMC or XMDJEN100 Cables
(sold separately)
Satellite Radio Tuner
(sold separately)
SAT R (Red)
SAT L (White)
Antenna
Battery
-
Connect the yellow wire to the battery
or 12 volt power source that is always
live. This wire MUST be connected
for the radio to work.
Yellow
Black
Chassis Ground
Connect the black wire to the factory ground wire. If a
factory ground wire is not provided, locate a clean,
unpainted metal part of the dash and secure the ground
wire with a "ring" terminal and a sheet metal screw.
NOTE: Video playback not supported for all
iPod
iPods. See iPod section for more information.
(Sold Separately)
White/Black
Gray/Black
White
Stripe
Left Speaker
(Front)
NOTE: Only connect speakers with a nominal impedance
of 4 ohms. Speakers with a load impedance less than 4
ohms could damage the unit.
Subwoofer Out
Parking Brake (Pink)
Camera In
Video Out 1
Video Out 2
Fuse (15A)
Camera/Active High Level Input (Green/White)
SWC (Steering Wheel Control)
(Requires PAC SWI-PS Interface Adapter)
Rear Line out
Gray
Front Line out
Black
FILTER
BOX
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Blue
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Red
FRONT REAR
Green/Black Green
Gray
Stripe
Stripe
Right Speaker Left Speaker
(Front) (Rear)
3
(Blue)
(Yellow)
(Yellow)
(Yellow)
R (Red)
L (White)
R (Red)
L (White)
IMPORTANT!
The pink parking
wire MUST be
Purple
Purple/Black
Stripe connected to the
switched side of the
parking break
circuit (the part that
becomes grounded
when the brake is
applied).
Right Speaker
(Rear)
+