Electrical Safety - Speedaire 35WC85 Manual De Instrucciones De Operación

GENERAL SAFETY INSTRUCTIONS (CONTINUED)
d. This unit must NOT be modified or used for any application other than that for which it was designed.
examine the unit closely for bent, cracked or broken parts. STOP and repair before using or serious
injury could occur.
f. Maintain the unit with care.
any maintenance.
g. Do not remove any labels from the unit.
h. Check all fasteners at frequent intervals for proper tightness.
i. Before each use, inspect compressed air system and electrical components for signs of damage,
deterioration, weakness or leakage. Repair or replace defective items before using.
j. Do not open the top housing cover while the device is op er at ing.
personal injury.

Electrical Safety

Follow all local electrical and safety codes as well as in the United States, the National Electrical Codes (NEC)
and Occupational Safety and Health Act (OSHA).
Electrical devices must always be securely and ad e quate ly grounded. All wiring must be done by a qualified
(certified or licensed) electrician.
voltage. Connect unit to a power line with the appropriate voltage.
gas or vapor. Never store flammable liquids or gases in the vicinity of the compressor.
of doors.
In the event of an electrical short circuit, grounding provides a path of least resistance for electrical current to
reduce the risk of electric shock.
Service
Service must be performed only by qualified repair personnel.
The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions in this manual cannot
cover all possible conditions and situations that may occur. It must be understood by the operator that
caution is a factor which cannot be built into this product, but must be supplied by the operator.
2
Do not make any modifications to the unit without first obtaining written approval
from Dayton Electric Manufacturing Company.
Do not drop or throw the unit. Dropping or throwing the unit can result in damage
that will make the unit unusable or unsafe. If the unit has been dropped or thrown,
Always disconnect, lockout and tag power before attempting to install, service,
relocate or perform any maintenance. Release all air pressure before performing
Never use gasoline or other flammable liquids to clean the unit. Vapors could
ignite by a spark and cause an explosion which will result in death or serious
To reduce the risk of electrical hazards, fi re hazards or damage to the unit, use
proper circuit protection. Your unit is wired at the factory for operation using 120
Motors, electrical equipment and controls can cause electrical arcs that will
ignite a flammable gas or vapor. Never operate or repair in or near a flammable
If not properly grounded, this unit can cause an electrical
shock, particularly when used in damp locations, in proximity of plumbing, or out
Save These Instructions
Do Not Discard