If the mains connection cable of this heated underblanket is damaged, it
•
must be disposed of. If it cannot be removed, the heated underblanket
must be disposed of.
When this heated underblanket is switched on:
•
– Do not place any sharp objects on it
– Do not place any heat sources, such as hot water bottles, heat
pads or similar, on it
The electronic components in the control warm up when the heated un-
•
derblanket is in use. For this reason, the control must never be covered
or placed on the heated underblanket when it is in use.
It is essential to observe the information relating to the following chap-
•
ters: Operation, Cleaning and maintenance, Storage.
If you should have any questions about using our devices, please con-
•
tact our Customer Services department.
4. Intended use
CAUTION
This heated underblanket is intended only for warming beds.
5. Operation
5.1 Safety
CAUTION
• The heated underblanket is fitted with a SAFETY SYSTEM. This sensor technology provides protection
against overheating across the entire surface of the heated underblanket with an automatic switch-off in
the event of a fault. If the SAFETY SYSTEM has turned off the heated underblanket, the display will not
show anything and will not light up.
• Please note that for safety reasons, the heated underblanket can no longer be operated after a fault has
occurred and must be sent to the specified service address.
• Do not connect the defective heated underblanket with another control of the same type. This would
trigger a permanent switch-off via the control safety system.
5.2 Initial use
• Starting from the foot of the bed, place the heated underblanket flat on
your mattress.
• Use the plug-in coupling to connect the control and heated underblan-
ket
• Then fit your sheet as usual so that the heated underblanket is between
the mattress and the sheet.
• Insert the mains plug into a suitable socket.
18