How To Use; Assembling The Food Processor - Black and Decker FP2650S Manual Del Usuario

BLEnDER JAR
† . Lid cap with measurement units (Part # FP60S-)
† . Lid (Part # FP60S-3)
† 3. 6-cup (83 ml) glass blender jar
(Part # FP60S- )
. Handle
† . Gasket (Part # FP60S- )
† 6. Blade assembly (Part # FP60S-6)
† 7. Jar base (Part # FP60S-7)
note: † indicates consumer replaceable/removable parts
SMALL WORKBOWL
† . 3-cup workbowl cover
(Part # FP60S-8)
. Extended tab
† 3. Small, stainless steel chopping blade
(Part # FP60S-0)
. Safety-lock slot
† . 3-cup processing workbowl
(Part # FP60S-9)
† 6. 3-cup processing workbowl storage lid
(Part # FP60S-)
note: † indicates consumer replaceable/
removable parts
COnTROL PAnEL
. Off/Pulse button
. High button
3. Low button
. Power indicator light
6






  

How to Use


This product is for household use only.

• Remove all packing material and any stickers from the product.

important: Handle chopping blades and slice/shred disc carefully.
They are very sharp.

• Please go to www.prodprotect.com/applica to register your warranty.
• Wash all removable parts as instructed in CARe ANd CleANING section

of this manual.

• Select a level, dry countertop where the appliance is to be used, allowing
air space on all sides to provide proper ventilation for the motor.


ASSEMBLinG THE FOOD PROCESSOR

insert and Remove the Center Post
The center posts of both bowls are removable:
B
C
D

E
1. Turn the bowl upside down.
2. Grasp the clear outer tabs and turn the center post
clockwise until the lower tabs are free. lift the post
out (B).
3. To return to its original position, place center post
into smaller opening in bottom of workbowl and turn
counterclockwise until tabs snap into place.
How to Lock the Large and Small Workbowls in Position:
1. Attach center post to workbowl. Place the workbowl on
the base with handle turned to the right of the locking
mechanism (C) over the unlock symbol
2. Hold handle and rotate workbowl clockwise toward the
lock symbol until it clicks firmly into place (D). Be
sure to lock the workbowl in place before attaching the
blades and cover.
Locking the Cover
1. Place cover over workbowl with the small latch to the
right of the workbowl's handle (E).
2. Hold feed chute of workbowl cover and rotate cover
clockwise until cover locks into place.
.
7