Idiomas disponibles
Idiomas disponibles
ENGLISH
F HOW TO USE
,
SHAVING
• Make sure your shaver is properly charged or use directly from the mains.
• Switch the shaver on.
• Stretch the skin with your free hand so the hairs stand upright
• Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
• Use short, circular strokes.
,
TRIMMING
• While your shaver is switched on, slide the on/off switch upwards to activate the
trimmer.
Push the trimmer release button.
• Hold the trimmer at a right angle to your skin.
• To retract the trimmer push the top rear of the trimmer downward until it locks under
the trimmer release button.
Tips for best results
E
• Ensure your skin is dry. Always hold the shaver at right angles to the skin so that all three
heads are touching the skin with equal pressure.
• Use moderate to slow stroking movements. The use of short circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid damage to the rotary heads.
C CARE FOR YOUR SHAVER
• Care for your appliance to ensure a long lasting performance.
• We recommend you clean your appliance after each use.
• The easiest and the most hygienic way to clean the appliance is by rinsing the appliance
head after use with warm water.
• Keep the trimmer in the "off" position when the shaver is not in use.
C CLEANING
,
DAILY
• Ensure the shaver is switched off and unplugged from the mains outlet.
• Open the shaver head by pressing the release button on the front of the shaver.
• Tap out excess hair shavings and use a cleaning brush if necessary.
• Close head assembly.
4
ENGLISH
,
MONTHLY
• Perform the daily cleaning steps first.
• Open the shaver head by pressing the release button on the front of the shaver and
flipping open the head away from the body of the shaver.
• Release the inner cutter carrier by rotating the locking arms counter-clockwise.
• Pull the inner cutter carrier away from the inner cutters.
• Thoroughly brush hairs from the inner and outer cutters and rinse out remaining debris.
• Replace inner cutter.
• Place the inner cutter carrier back onto the upper hairpocket and lock in place by
rotating the locking arms clockwise until the arms 'click' into place.
,
REPLACE HEAD WARNING
• The replace head icon will flash at 1 sec interval every time the shaver reaches 600
minutes of operation.
• The replace head icon will flash for 9 minutes and then turn off. If the shaver is turned off
and then on the icon will continue to flash until the total time the icon flashes has
reached 9 minutes.
• If the replace head icon is flashing when the shaver is turned off it will continue to flash
for 15 seconds and then stop.
C TRIMMER
Lubricate the teeth of the trimmer every six months with one drop of sewing machine oil.
F IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO
PERSONS:
• An appliance should never be left unattended when plugged in to a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Make sure the power plug and cord do not get wet.
• Do not plug or unplug the appliance with wet hands.
• Do not use the product with a damaged cord. A replacement can be obtained via our
International Service Centres.
Do not twist or kink the cable, and don't wrap it around the appliance.
• Store the product at a temperature between 15°C and 35°C.
• Only use the parts supplied with the appliance.
• The appliance, including its cord, must not be used, played with, cleaned or maintained
by persons under eight years old and should at all times be kept out of their reach.
Use, cleaning or maintenance of the appliance by children over eight or by anyone with
a lack of knowledge, experience or with reduced physical, sensory or mental capabilities
should only be undertaken after receiving appropriate instruction and under the
5
