THOMSON ANTUSB1428 Instrucciones De Uso página 4

G Operating Instructions
Thank you for choosing a Thomson product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the device,
please pass these operating instructions on to the new
owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to speci c hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package contents
• DVB-T at antenna
• Power supply unit
• USB cable
• Antenna cable
• Base
3. Controls
1. Coax socket
2. USB socket
3. DC socket (power supply unit)
4. Dial
4. Safety Notes
• The product is intended for private, non-commercial use only.
• The product is intended for indoor use only.
• Use the product for its intended purpose only.
• Protect the product from dirt, moisture and overheating
and use it in dry rooms only.
• Children should be supervised to ensure that they do not
play with the device.
• Do not use the product in areas where the use of elec-
tronic devices is not permitted.
• Connect the product only to a socket that has been ap-
proved for the device. The electrical socket must always
be easily accessible.
• Disconnect the product from the network using the
power button – if this is not available, unplug the power
cord from the socket.
• Lay all cables so that they do not pose a tripping hazard.
• Do not bend or crush the cable.
• Do not drop the product and do not expose it to any
major shocks.
• Dispose of packaging material immediately according to
locally applicable regulations.
2
• Do not modify the device in any way. Doing so voids the
warranty.
Warning
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the device
yourself. Leave any service work to quali ed experts.
• Do not open the device or continue to operate it if it
becomes damaged.
5. Speci cations
Supply voltage
Rated power
consumption
Frequency band(s)
Active antenna gain
Impedance
Connection
Ambient temperature
6. Startup and Operation
Depending on country and VHF or UHF frequency band
of the channel to be received, the antenna must be
positioned vertically (Fig. 1, A) or horizontally (Fig. 1, B).
Place the antenna on the base in the desired position.
Note
Please note that the number and quality of stations
received may vary depending on the position of the
antenna and local conditions.
6.1 Powering the antenna using a power supply
unit (Fig. 2)
• Connect the supplied antenna cable to the coax socket
(1) of the antenna and to the antenna input of the set-
top box (or digital TV).
• Connect the power supply unit to the antenna's DC input
(3) and plug the power supply unit into an electrical socket.
(Please use only the power unit supplied with the product.)
• Switch on the antenna using the power switch.
• Switch on the TV (and the set-top box, if present).
• Check the reception quality. If the reception quality is
not good, adjust the position or angle of the antenna.
Depending on the station, the ampli er power must be
adjusted using the dial (4) on the side.
230 V / 50 Hz
max. 100 mA
UHF: 470 – 790 MHz
VHF: 174 – 230 MHz
UHF: 6 – 16 dBi
VHF: 4 – 9 dBi
75 ohm
Coax plug
-20 to +40° C