Intended Use; Safety Instructions; General Power Tool Safety Warnings; Work Area Safety - SKF LINCOLN PowerLuber A Serie Guía De Instalación Y Mantenimiento

Intended use

This PowerLuber was exclusively designed
to pump and dispense lubricant using 12 V
battery power. Do not exceed the maximum
specification ratings.

Safety instructions

General power tool safety
warnings
Warning

Read all safety warnings and
instructions. Failure to follow
the warnings and instructions
may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future
reference. The term "power tool" in the
warnings refers to your mains-operated
(corded) power tool or battery-operated
(cordless) power tool.

1 Work area safety

1.1 Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
1.2 Do not operate power tools in explo-
sive atmospheres, such as in the
presence of flammable liquids, gases
or dust. Power tools create sparks
which may ignite the dust or fumes.
1.3 Keep children and bystanders away
while operating a power tool.
1.4 Distractions can cause you to lose
control.

2 Electrical safety

2.1 Power tool plugs must match the out-
let. never modify the plug in any way.
Do not use any adapter plugs with
earthed (grounded) power tools.
Unmodified plugs and matching out-
lets will reduce risk of electric shock.
2.2 Avoid body contact with earthed or
grounded surfaces such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric
shock if your body is earthed or
grounded.
2.3 Do not expose power tools to rain or
wet conditions. Water entering a
power tool will increase the risk of
electric shock.
2.4 Do not abuse the cord. Never use the
cord for carrying, pulling or unplug-
ging the power tool. Keep cord away
from heat, oil, sharp edges or moving
parts. Damaged or entangled cords
increase the risk of electric shock.
3
2.5 When operating a power tool out-
doors, use an extension cord suit-
able for outdoor use. Use of a cord
suitable for outdoor use reduces the
risk of electric shock.
2.6 If operating a power tool in a damp
location is unavoidable, use a residual
Current Device (RCD) protected
supply. Use of an RCD reduces the risk
of electric shock.

3 Personal safety

3.1 Stay alert, watch what you are doing
and use common sense when
operating a power tool. Do not use a
power tool while you are tired or
under the influence of drugs, alcohol
or medication. A moment of inatten-
tion while operating power tools may
result in serious personal injury.
3.2 Use personal protective equipment.
always wear eye protection.
Protective equipment such as dust
mask, non-skid safety shoes, hard
hat, or hearing protection used for
appropriate conditions will reduce
personalinjuries.
3.3 Prevent unintentional starting.
Ensure the switch is in the off-posi-
tion before connecting to power
source and/or battery pack, picking up
or carrying the tool. Carrying power
tools with your finger on the switch or
energising power tools that have the
switch on invites accidents.
3.4 Remove any adjusting key or wrench
before turning the power tool on.
A wrench or a key left attached to a
rotating part of the power tool may
result in personal injury.
3.5 Do not overreach. Keep proper footing
and balance at all times. This enables
better control of the power tool in
unexpected situations.
3.6 Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewellery or long
hair can be caught in moving parts.
3.7 If devices are provided for the connec-
tion of dust extraction and collection
facilities, ensure these are connected
and properly used. Use of dust collec-
tion can reduce dust-related hazards.