FITFIU FITNESS GYM-100 Manual Usuario página 32

ASSEMBLY STEPS
NOTE
Don't fully tighten all boits before
the entire unit has been completely
assembled.
STEP I
1. Attach the Rear Stabilizer (03) to the Base
Frame (01) and tighten by X2 Hex Head Bolt
(30), X4 Curve Washer (34) and X2 Nylon Nuts
(38).
2. Attach the Front Stabilizer (04) to the Base
Frame (01) and tighten by X2 Hex Head Bolt
(30), X4 Curve Washer (34) and X2 Nylon Nuts
(38).
3. Attach the Upright Support Tube (02) to the
Base Frame (01) and tighten by X2 hex Head
Bolt (30), X4 Flat Wahser (34) and X2 Nylon
Nuts (38).
STEP 2
1. Slide both Guiding Tube (05) through Rubber
Ring (47) into the 2 holes on the Rear
Stabilizer (3), tighten from the bottom side
by X2 Curve Washer (33) and X2 Hex Head
Bolt (22).
2. Place the Weight Stack (63) into the Guiding
tube (05). (Watch out personal safety)
3. Place the Bushing for Weight Stack (55) onto
the Select Bar (12) and fixed by the Fixed Pin
(40). Then place the Weight Stack (62) upper
the Select Bar (12) and place the Flat Washer
(36) upper the Weight Stack (62).
4. Insert the Select Pin (32) through the Weight
Stack (63) into the hole of Select Bar (12).
32