On/Off Cycling Of Compressor; Moisture In Compressed Air - Kobalt VT6389 Manual De Instrucciones

OPERATING INSTRUCTIONS

ON/OFF CYCLING OF COMPRESSOR

WARNING
Risk of Bursting. Drain tank every day to
prevent corrosion and possible injury due to
tank damage. Do not operate drain with more
than 40 psi in tank or drain valve may be
damaged. Drain tank of moisture daily using
the drain valve in the bottom of the tank.
In the AUTO position, the compressor pumps air
into the tank. When a shut-off (preset "cut-out")
pressure is reached, the compressor automatically
shuts off.
If the compressor is left in the AUTO position
and air is depleted from the tank by use of a
tire chuck, tool, etc., the compressor will restart
automatically at its preset "cut-in" pressure. When
a tool is being used continuously, the compressor
will cycle on and off automatically.
In the OFF position, the compressor will not
operate.
Drain Tank. Disconnect, tag, unplug and lock out
power source; release pressure. Drain moisture
from tank by opening drain valve underneath tank
(See Figure 1).
Moisture in compressed air will form into droplets as it comes from an air compressor pump.
When humidity is high or when a compressor is in continuous use for an extended period of time,
this moisture will collect in the tank. When using a paint spray or sandblast gun, this water will
be carried from the tank through the hose, and out of the gun as droplets mixed with the spray
material.
IMPORTANT: This condensation will cause water spots in a paint job, especially when spraying
other than water based paints. If sandblasting, it will cause the sand to cake and clog the gun,
rendering it ineffective. A fi lter in the air line, located as near to the gun as possible, will help
eliminate this moisture.

MOISTURE IN COMPRESSED AIR

14
NOTICE
Unit care and maintenance. Drain liquid from
tank daily.
1
Bottom Drain Valve