Wolf E Serie Guia De Instalacion página 11

IN S TA L L AT I O N
Installation
Place the oven in the opening and slide back. Verify the
conduit slides through the opening of the base support
and is not trapped between the oven and cabinet wall. The
conduit must fit into the recessed area along the right rear
edge of the oven.
Locate the mounting holes on the oven side trim, two on
each side for a single oven and three on each side for
a double oven. Drill 1 / " pilot holes. Use the provided
16
mounting screws to secure the oven to cabinetry. Refer to
the illustration below.
CAUTION
Failure to install the mounting screws may cause the
oven to tip forward during use.
CAUTION
For proper ventilation, do not block the exhaust vent
located at the bottom of the oven.
C ON TR O L PA NE L A L I G N M E N T
To adjust alignment, open the oven door and loosen the
two screws under the control panel. Pivot the bottom of the
control panel in or out, then tighten the screws. Refer to the
illustration below.
MOUNTING
HOLES
Mounting holes
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
SCREWS
Control panel alignment
Troubleshooting
IMPORTANT NOTE: If the oven does not operate properly,
follow these troubleshooting steps:
• Verify electrical power is supplied to the oven.
• Verify proper electrical connections.
• If the oven does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
oven. Wolf is not responsible for service required to
correct a faulty installation.
|
wolfappliance.com 11