peerless-AV FPE47F-S Instalación Y Ensamblaje página 12

For Flat Back Display
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as
6 -1
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
6 -2
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
Display
Display
SPACER
12 of 50
MULTI-WASHER
SCREW
ADAPTER BRACKET (B)
MULTI-WASHER
SCREW
ADAPTER BRACKET (B)
ISSUED: 07-12-10 SHEET #: 061-9056-8 03-05-13