Setup Instructions - Polygroup SUMMER WAVES ST1100 El Manual Del Propietario

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING:
CLIMBING HAZZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTRATION SYSTEM TO GAIN ACCESS TO THE POOL.
Tools required:
Flat-blade screwdriver (not included)
1. Set up the pool by following all the instructions that came with
the pool. Do not fill water until the Filter Pump is properly
installed. Locate the Outlet and Inlet openings on the pool wall.
Inlet
3. Install the Return Fitting 30
32
31
30
29
Inside Pool Wall
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.

SETUP INSTRUCTIONS

Outlet
on the Inlet opening of the pool.
Outside Pool Wall
26
Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
2. Install the Suction Fitting 22
Outside Pool Wall
23
24
4. Snap the Pump on to the Sand Tank Base
17
17
on the Outlet opening of the pool.
22
21
Inside Pool Wall
.
1
1
9