Mounting Procedure - Bose 151 Guia Del Usuario

® ®
The Bose 151

Mounting procedure

Figure 3
Exploded view of speaker
and mounting bracket
Figure 4
Mounting the brackets
4
SE Environmental Speakers
1. Remove screw C and lock washer D from the mounting bracket assembly, and remove
part B from part A (Figure 3).
A
D
C
E
F
2. Hold bracket part A in position against the wall and mark the left and right round holes for
the mounting hardware (Figure 4). If you plan to feed speaker cord through the wall, mark
the oval speaker cord feed-through hole also.
A
H
G
Mount bracket A with
locking screw on the left.
3. Drill holes using the appropriate drill bits for the wall material. Refer to "Required tools
and materials" on page 3.
Note: If you plan to feed the speaker cord through the bracket, feed the cord through the wall
before mounting the bracket.
4. Mount bracket part A to the wall using the appropriate hardware for wood (G) or concrete
(H and G). Make sure the hole for the bracket locking screw is on your left (Figure 4).
5. Mount bracket part B to the rear of the speaker using two machine screws E and two
lock washers F (Figure 4).
Speaker cord
B
Mount bracket B with
flat end next to terminals.
F
E
Speaker cord
B