Chapter 2. Machine Installation; Transport And Positioning; Environmental Conditions; Electrical Connections - Minipack-Torre Galileo Instrucciones Para La Instalación, Uso Y Mantenimento

Chapter 2. Machine installation

2.1. Transport and positioning

It is recommended to handle with great care during transport and positioning!
Use protection gloves while handling the machine.
!
Cut the strap with scissors make sure you protect your eyes by wearing glasses and withdraw the cardboard.
Remove the screws and any plate intended to fasten the machine to the pallet (figure 2.1.A page 65).
!
Remove the waste film rewinder (where expected).
!
Remove the cardboard containing the trolley.
!
Assemble the trolley (figure 2.1.B page 65).
!
Lift the machine and arrange it on the trolley. Make sure that the 4 trolley legs are well inserted into the 4 slots on
the bottom of the machine (figure 2.1.C page 65).
If it is transported by hand, 4 people are required for its transportation.
When lifting the machine, always grip it by the ends and never by the reel support (5) (figure 2.1.C
page 65).
!
Remove the upper hood by cutting the strings.
!
Position the waste film rewinder (where expected) according to the attached instructions.

2.2. Environmental conditions

!
Place the machine in a suitable environment free from humidity, gases, explosives, combustible materials.
!
Leave a minimal space of 200mm around the machine so that not to obstruct air outlets (figure 2.2. page 66).
!
Once the correct height is abtained, block the machine by means of the wheel brakes.
Working environmental conditions:
!
Temperature from + 5°C to + 40°C
!
Relative humidity from 30% to 90%, without condensation
The lighting of the operation room shall comply with the laws in force in the country where the machine is installed.
However, it shall be uniform and provide for good visibility in order to safeguard the operator's safety and health.
MACHINE SAFETY FACTOR = IP20
THE AERIAL NOISE MADE BY THE MACHINE IS LOWER THAN 70 dB

2.3. Electrical connections

OBSERVE HEALTH AND SAFETY REGULATIONS!
If the machine is not equipped with the power supply plug, use a plug that is suitable for the voltage and
amperage values described by the rating plate and that can comply with the rules in force in the installation
country.
GROUNDING OF THE UNIT IS OBLIGATORY! (figure 2.3. page 66).
Before executing electrical connections, make sure the mains voltage matches the one on the plate on machine rear and
that the ground contact complies with the safety rules in force.
In case of doubts about the mains voltage, contact the local public supply Company.
If the power supply cable is damaged, it must be replaced by the manufacturer or its technical assistance
service or, anyway, by a similarly qualified person, so as to avoid any risk.
N.B.: THE DEVICE MAY CAUSE TRANSIENT VOLTAGE DROPS ON UNFAVOURABLE POWER SUPPLY
CONDITIONS.
12
GB