BEFORE WASHING OR STORING YOUR THROW:
1.
Disconnect the control unit from the mains socket (3).
2.
Disconnect the connector (2) from the throw by pressing the push buttons at the sides of the control
connector (1).
EN
3.
Ensure that the controls are not connected and none of the wires have worn through the fabric.
4.
It is important to measure the throw before washing and check that the dimensions are approximately the
same before drying.
MACHINE WASHING
• The throw can be machine washed at 40°C on a wool programme.
• Only the gentle spin cycle is to be used. DO NOT use an extra spin cycle.
TUMBLE DRYING
• Tumble dry at a low temperature.
• Remove the thrown from the tumble dryer at the end of the drying cycle and hang it out to dry completely.
• Do not use the throw until it is completely dry.
HANGING THE THROW OUTSIDE TO DRY
• The throw must be stretched back to approximately its original size during the drying process. This is best
done whilst damp, working from side to side, stretching a piece at a time. This procedure may need to be
repeated a few times until fully dry.
• Make sure the wires are not kinked or twisted. It is easier to check the wires by placing the throw against the
light.
WARNING! Examine the appliance against the light to make
sure the cables are not bent or twisted.
WARNING! If the appliance does not resume its original size or
if problems arise with the internal cables contact an authorised
service centre for a safety check.
WARNING! Hang the appliance without applying pegs so as
not to damage it.
When not in use, store as follows:
•
Make sure your throw is dry if it has been washed.
•
Fold your throw loosely being careful not bend the wires too forcefully
•
It is recommeded to store the throw in the bag it was purchased in.
•
Store the throw in a dry place
When storing the appliance, allow it to cool down before folding.
WARNING!
on top of it during storage.
14
STORING THE THROW
DO NOT crease the appliance by placing items