Seals; Glass - Hergom HERITAGE Libro De Instrucciones Para Instalación, Mantenimiento Y Uso

It is therefore recommendable that before each season when the stove is to be used, a
professional should be called to inspect the whole system, clean it and repair it if necessary.

2.2.2 - SEALS

The joints normally have to be changed every 2 or 3 seasons of use, depending on how
much the stove is used. If the seal on the door is lost, a new seal must be installed to improve
the operation of the stove. Contact your supplier for a set of seals for your stove.
To replace the seals on the door, proceed as follows:
6. First remove the old one with a tool or the end of a knife.
7. Clean all of the channels of the seal with a wire brush to eliminate the remains of
cement and fibres.
8. Apply a suitable glue for seal in the seating channels.
9. Pur a new seal in place on the seal adhesive without stretching the material.
10. Close the door immediately to squeeze the joint in its place and ensure a valid seal.
The use is required of the following seals:
FRONT DOOR: 1.70 m in length, 10 mmin diameter. A low density black strip (code J38)
GLASS: 1.50 m in length and 6.5 mm. in diameter, (code J14)
SIDE DOOR : 1.25 m in length and 10 mm in diameter. Low density black strip (code.
J38)
ASH TRAY DOOR : 0.90 m in length and 6.5 mm in diameter (code J14)

2.2.3 - GLASS

Do not use your stove if the glass in the door is broken. Do not submit the front door to
knocking or slamming.
If necessary, you can clean the glass in the door with an Hergóm glass cleaner, which
will be supplied by your supplier.
Never try to clean the glass when the stove is worling or when the glass is hot.
Most of he particles that settle can be cleaned by following the instructions of use of the
cleaner.
To clean difficult particles, open the door by draughting upwards and removeing it from
the stove, leaving the hinge pins free (take care to keep the pins and the washers in order to
refit the door).
Put the door on a table or working bench and apply the cleaner to the glass, leaving it to
work for a few minutes.
Leave the door in a horizontal position to allow the cleaner to penetrate the surface of the
glass better.
Clean the cleaner using a soft cloth.
Important: Knocking or scratching the glass will harm the integrity of the glass. Do
not use blades or steel sponges or any other abrasive material as a utensil to clean the glass.
48