Adjusting Nylon Line - Stihl FSB-KM Manual De Instrucciones

8
7
3
STIHL PolyCut 5-3
: Place the nut (8) in the mowing
head.
: Screw the mowing head (7)
clockwise onto the shaft (3) as far
as stop.
: Use stop pin to block the shaft.
: Tighten down the mowing head
firmly.
Remove the stop pin.
FSB-KM
2

Adjusting Nylon Line

STIHL AutoCut 11-2
: Hold the rotating mowing head
horizontal to the ground – tap it on
the ground – about 3 cm (1 1/4")
fresh line is advanced.
: The blade (1) on the deflector (2)
trims surplus line to the correct
length. Avoid tapping the head more
than once.
Line feed operates only if both lines
are at least 2.5cm (1") long.
Removing the Mowing Head
: Block the shaft.
: Unscrew the mowing head
counterclockwise.
Fitting New Nylon Line
1
AutoCut
See chapter on "Replacing the Nylon
Line".
Replacing Thermoplastic Blades
PolyCut
Follow the instructions supplied with the
mowing head.
English / USA
19