Selecting Scenes; Temporarily Adjusting Light Levels And Shade Positions - Lutron GRAFIK Eye 4000 Serie Manual De Instalación

Ocultar thumbs Ver también para GRAFIK Eye 4000 Serie:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
Section 5:
Using the GRAFIK Eye
NOTE: For slider units, this section is covered in the Addendum included with those units.
This section describes how to use your GRAFIK Eye control unit, including selecting scenes, making temporary 
changes, and setting up system communications.

Selecting Scenes

ZONE 5
ZONE 6

Temporarily Adjusting Light Levels and Shade Positions

You can temporarily adjust the light level or shade position of a zone. Temporary adjustments remain in effect only 
until a new scene selection occurs.
NOTE: For control units set to bd save mode (refer to page 21), temporary adjustments can be made only using a 
wallstation, shade controller, or IR control.
ZONE 5
ZONE 6
ZONE 
raise/lower 
buttons
LED Displays for Temporarily Changing Lighting Settings
Lighting
Level (%)
LED DIsplay
0
1-13
14-28
29-42
Legend:
LED lit
LED off
22     GRAFIK Eye
 4000 Series Control Unit Installer's Guide 
®
FADE
TEMPORARY
ZONES
M S
MASTER
Scene 1
Scene 2
Scene 3
Scene 4
OFF
TEMPORARY 
LED
FADE
TEMPORARY
TEMPORARY 
ZONES
ZONES
M S
MASTER 
MASTER
raise/lower
SCENE 
buttons
Lighting
Level (%)
43-56
57-70
71-85
86-100
Control Unit
®
To select a scene, press the corresponding SCENE 
button on the control unit. The first button calls up scene 
1; the second button, scene 2; and so on. The last button 
is the OFF scene.
Scenes 1 through 4 (and OFF) can be selected on the 
control unit.
Scenes 5 through 16 are selected only by using 
wallstations and other optional control interfaces. (For 
installation and setup procedures, refer to the separate 
instructions provided with the wallstation or interface.)
To temporarily adjust all lighting zones:
1. Press the appropriate scene button.
2. To raise or lower the intensity of all lighting zones 
in the scene, press the MASTER 5 or 6 button. 
(This will not affect shade zones or unaffected 
lighting zones.)
To temporarily adjust a lighting zone:
1. Press the TEMPORARY ZONES button so the 
TEMPORARY LED above the TEMPORARY ZONES 
button lights. 
2. Press the ZONE 5 or 6 button to adjust any 
zone's light level.
LED DIsplay
R

Solución de problemas

loading

Este manual también es adecuado para:

Grafik eye 4100Grafik eye 4500