HAMPTON BAY CAMPBELL 51350 Guía De Uso Y Mantenimiento página 8

Assembly - Close-To-Ceiling Mount
1
Preparing for mounting
□
Remove the slide-on mounting bracket (A) from the canopy (C)
by loosening the four screws (SS) on the top of the canopy (C).
□
Remove the two non-slotted screws (SS) and loosen the slot-
ted screws (SS).
□
Remove the decorative canopy bottom cover (L) from the
canopy (C) by depressing the three stubs.
SS
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock, or
other personal injury, mount the fan to an outlet box or
supporting system marked acceptable for fan support and
use the mounting screws provided with the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□
Install the ceiling slide-on mounting bracket (A) on the outlet
box by sliding the slide-on mounting bracket (A) over the two
screws (TT) provided with the outlet box. If necessary, use leveling
washers (not included) between the slide-on mounting bracket
(A) and the outlet box. Note that the flat side of the slide-on
mounting bracket (A) is toward the outlet box.
□
Securely tighten the two mounting screws (TT).
2
Routing the wires
□
Remove three of the six screws and lock washer (QQ) (every
other one) securing the motor collar (M) to the top of the fan-
motor assembly (D).
□
Place the rubber gasket (FF) over the remaining three screws,
route the wires existing the top of the fan-motor assembly (D)
through the canopy (C) (make sure the slot opening are on top),
then proceed to place the canopy (C) over the collar at the top
A
of the fan-motor assembly (D).
□
Align the mounting holes with the holes in the motor and
fasten, using the three screws and lock-washers (QQ) removed
previously. Tighten the mounting screws securely.
C
L
2
Hanging the fan
□
Carefully lift the fan-motor assembly (D) up to the slide-on
mounting bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the mounting bracket socket. Ensure that the tab on the
slide-on mounting bracket (A) socket is properly seated in the
groove in the hanger ball. If using close-to-ceiling mounting,
hang the fan on the hook provided by utilizing one of the holes
at the outer rim of the ceiling canopy (C).
A
C
D
8
C
QQ
FF
WARNING: The hook as shown is only to balance the fan
while attaching wiring. Failure to hang as shown may
result in hook breaking, causing the fan to fall. The hook
must pass from inside to the outside of the canopy (C).
M
D
A
B
C
D