HEINE DELTA one Manual Del Usario página 9

If the device is switched off, the charge indicator remains on for a further 3 seconds and then goes off.
Do not look directly into the light source when checking the charge level.
Operation
To switch on the illumination, press the button (1, 9) on the instrument. The device starts with the last
selected brightness level and in polarisation mode.
Press the button (6, 11) to adjust the brightness in three steps.
The device switches off automatically after 10 minutes if the polarisation buttons or the brightness control
are not used.
Contact mode (with contact plate)
Place the contact plate (3, 12) on the instrument, making sure that it snaps into place.
Place the instrument with the contact plate onto the area of skin being examined. With DELTAone, extend
the contact plate (3) over the focusing ring (2).
When carrying out examinations with polarised illumination, you do NOT need any contact liquid such as
immersion oil or disinfection spray. In polarised mode, the polarisation indicator (8, 14) lights up blue.
Use the polarisation button (7, 10) to switch to non-polarised mode. In this case, use a contact fluid such
as immersion oil.
Adjusting the focus in contact mode
Your eye needs to be at a distance of approximately 2 cm from the focusing ring (2, 13). Rotate the focusing
ring until you see a sharp image. The image has 10-fold magnification.
Non-contact mode (without contact plate)
Take off the contact plate (3, 12) and hold the device at a distance of approximately 1 cm above the area of
skin being examined. Use the polarisation button (7, 10) to switch to non-polarised mode.
Adjusting the focus in non-contact mode
Your eye needs to be at a distance of approximately 2 cm from the focusing ring (2, 13).
With DELTA30, rotate the focusing ring (13) until you see a sharp image.
With DELTAone, the focus is adjusted via the distance between the skin and the optics. There is no need
to rotate the focusing ring (2).
The image has 10-fold magnification.
Smartphone Adapter
To connect the dermatoscope to a smartphone, you need a suitable adapter for your smartphone.
Place the adapter onto the focusing ring (2, 13). The adapter is held in place by magnetic force.
Install the corresponding app on your smartphone. The app is available in the App Store*.
To avoid any possible malfunctions, please deactivate all other services (switch on flight mode).
*App Store is a service mark of Apple Inc.
Protecting patient data is users' sole responsibility (e. g. protection of the smartphone with a pin, data
transmission via a secure connection). Ensure that your smartphone is adequately protected against
access by third parties.
An electrical conducting connection between smartphone, PC and a mains power source is not
permissible during the recording of the picture.
All images are saved exclusively on the smartphone in the app's sandbox. The user is responsible for
the regular creation of a data backup to prevent data loss, which can happen for example through
deleting the app or losing the smartphone. A data backup can be made via cable to another computer
or via the network to the iCloud.
MED 176623 2019-09-12
9/52