Care And Maintenance - babymoov Chaise Haute Slim Instrucciones De Uso

B. Press the buttons on both sides inside the high chair simultaneously spreading out the two non-slip legs (a)
(Figure 1).
C. When the two legs (a) are fully spread out, go behind the high chair, press the folding handle (b) by pushing
down on it firmly with your hand and directing it to the left. At the same time, hold the back (d) with your other
hand and lift it up until you hear a click (Figure 2).
D. To adjust the height of the high chair, stand in front of it, push down the two buttons (c) on both sides of the front
of the high chair, simultaneously raising or lowering the high chair to the desired height (Figures 3, 4 and 5).
Advice: to facilitate the adjustment of the high chair, lay the horizontal part of the non-slip leg (a) flat.
E. To adjust the removable tray (e), pull the button towards you (f) inwards or outwards (Figure 6). To remove the
removable tray (e), pull it fully outwards (Figure 7).
F. To fit the removable over-tray (h), clip it into the openings either side and lay it on top of the removable tray
(e) making sure it covers the edges of the removable tray (e). To remove the removable over-tray (e), lift it up
(Figure 8).
G. To adjust the angle of the back (d), pull button (g) and simultaneously tilt the back (d) forwards or backwards
(Figure 9).
H. To remove the protective cover (i), open the zip fastening in the back of the cover (i) (Figure 10). Open the two
press studs either side of the cover, as well as the four press studs under the seat (i). Lift off the protective cover
(i) from the back (d). To remove the 5-point safety harness (j) : tilt the end pieces connected to the straps of
the harness (j) and at the back of the protective cover (i), so as to pass them through the protective cover (i)
(Figure 11). Do the same with the metal rectangle under the seat of the protective cover (i).
I. To fold up the high chair, stand behind it, press down on the folding handle (b) firmly with your hand and shift
it to the left. Gently bring the back (d) forwards (Figure 12). Before folding, make sure that the high chair is adjusted
to the highest position so that the back (d) does not touch the floor when folding. When the back (d) is fully folded,
press the buttons inside the non-slip legs (a) (Figure 13) and bring the two legs (a) together (Figure 14).
Your product requires a minimum of maintenance. THE CLEANING AND CARE OPERATIONS MUST ONLY BE
PERFORMED BY ADULTS.
• Check the high chair often for loose screws, worn parts, torn fabrics, or stitching that has come undone.
• Clean the plastic parts regularly with a damp cloth, do not use solvents or similar products.
• Do not dip the PVC protective cover (i) in water. Surface clean with a damp cloth and neutral detergent.
• Change or repair parts if required. Only use spare parts recommended by Babymoov.
• Protect the product from weathering agents, water, rain or snow.
• Excessive exposure to the sun or heat may cause fading of parts.
• 50 % Polyester - 50 % PVC
tInaj
8

CARE AND MAINTENANCE

SLIM HIGH CHAIR • Instruction manual