Drive Speed Adjustment; Driving Screws; Trigger Lock; Depth Of Drive Adjustment - Senco DURASPIN DS222-18V Instrucciones Para La Operación

DriVe SPeeD ADjuStMeNt

low speed tools can be switched from 2500 to 1600 rPM for driving self-drilling and tapping screws
into heavy steel applications. this can be done by depressing the drive speed adjustment button shown
in Figure 1. A red leD will indicate that low speed mode (1600 rPM) is engaged. click the button again
to toggle back to normal mode (2500 rPM).
the most recently selected mode will be maintained indefinitely until the user presses the button again.

DriViNG ScrewS

1. whenever possible, hold the tool at a right angle to the work surface.
2. Pull the trigger to start the motor.
3. Press the nosepiece with constant force against the work surface. Do not remove the tool from the
work surface until the clutch disengages and the bit stops rotating, signalling a fully driven screw.
4. continue to allow the motor to run. the next screw will be automatically fed into place when the tool
is pulled off the work surface.
CAUTION
During the driving process it is possible for the tool to "cut-out" or stop the motor
prematurely as a safety function to preserve the tool. if the motor senses a torque spike, an over-current
protection function will activate. A partially driven screw can be driven fully by squeezing the trigger
again to reset the tool/motor. if this cut-out occurs repeatedly, please review the troubleshooting sec-
tion for more details, or discontinue use in that application.

triGGer lock

to lock the trigger for continuous operation, depress the trigger and push in the locking button then
release the trigger. the tool will continue to run. to turn off, squeeze and release the trigger.

DePtH oF DriVe ADjuStMeNt

this tool is equipped with a locking depth control adjustment:
1. release the thumbwheel by depressing the red lock button.
2. Adjust the countersink by turning the depth adjustment thumbwheel.
3 refer to the markings on the tool for proper direction.
4. release the lock button after adjustment.
test drive screws while adjusting until the desired countersink is reached.
this tool has a depth-sensing clutch. when the screw is countersunk to the preset depth, it
automatically disengages and makes a click or ratcheting sound. this is normal and signals completion
of the drive.
tool oPerAtioN
10