Microtouch™ Display C1500Ss Installation Guide; Important Notes; Service And Repair Indicators - 3M MicroTouch C1500SS Manual De Instrucciones

3
CHAPTER 1
Intended Use
The 3M™ Touch Systems Touch Displays are designed for touch input and tested to
replace an existing display. These displays are intended for professional installation and
use in an indoor environment. They are not designed or tested for use in hazardous
locations. Use in any other application has not been evaluated by 3M and may lead to
an unsafe condition.

Important Notes

 Plug power cord into appropriate power source.
 Plug power cord into a grounded receptacle.
 When unplugging power supply cord, pull on plug not cord.
 Do not connect or disconnect this product during an electrical storm.
 Install the display in a well-ventilated area. Always maintain adequate ventilation to
protect the display from overheating and to ensure reliable and continued operation.
 Remember to take into account that the operating temperature of the installation may
be greater than the room ambient, and consideration should be given to installing the
unit in an environment compatible with the maximum rated ambient temperature.
 When installing the unit, ensure that it does not restrict the flow of air to any other
equipment within the installation required for safe operation.
 Do not expose this display to direct sunlight or heat. Passive heat may cause damage
to the metal case and other parts.
 Do not install this display in areas where extreme vibrations may be generated. For
example, nearby manufacturing equipment may produce strong vibrations. The
vibrations may cause the display to exhibit picture discoloration or poor video
quality.
 Ensure the metal enclosure does not contact the touch sensor.
 Be sure to gasket display to enclosure properly.
 To avoid ergonomic concerns:
Do not install the display in a manner or location with awkward accessibility.
Extended use may result in muscle, tendon, or fixed posture strains. It is
recommended you take periodic breaks from continuous use.

Service and Repair Indicators

Do not attempt to service this unit yourself. Removing the display cover may expose you
to dangerous voltage or other risks. Unplug the display from the power outlet and refer
servicing to qualified service personnel in the event that:

Liquid is spilled into the product or the product is exposed to rain or water.

The product does not operate properly when the operating instructions are followed.

The product has been dropped or the metal case has been damaged.
TSD-30219
3M™ MicroTouch™ Display C1500SS Installation Guide
Rev F