How To Use - Black and Decker VC2500 Manual Del Usuario

VC2500Pub1000001165 7/20/04 10:40 AM
C
1. Lid
2. Lid release
† 3. Dust filter (Part #VC2500-27)
† 4. Bracket (Part #VC2500-29)
5. Clip
† 6. Permanent dust bag with dust bag collar (Part #VC2500-32)
7. Dust bag compartment
† Consumer replaceable
Page 6
5
ASSEMBLING/DISASSEMBLING YOUR VACUUM CLEANER
Flexible Swivel Hose
1. To connect hose, push swivel connector end into the
opening on the front of the vacuum canister until it clicks
into place (D).
D
2. To remove, press the release button on the hose swivel
connector and pull out (E).
E
Extension Tube
1. To connect tubes, first connect the tube that has storage clip. Push end closest to
the clip into sweeper.
Tip: Rotate tube until storage clip faces the back side of the tube. This will make it
easier to store unit
2. Connect the other tube by pushing in one end into the
first tube and the other end into the thin end of flexible
hose (F).
Tip: You might have to twist tube slightly for a firm fit.
3. To remove extension tubes, just pull out the ends of each
tube.
F

How to Use

This appliance is intended for household use. It is for indoor use only.
Important: The power cord has a yellow marking and a red marking to help you
determine the maximum length to use. Up to the yellow mark is the recommended
length. Never pull cord beyond the red marking.
1. Holding the power cord by the plug, pull out the required length and plug into a
standard electrical outlet.
2. With your foot or hand, press the On/Off push button to
start the vacuum cleaner (G).
G
6