Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English / USA
9
9
8
8
1
5
6
7
10
10
Mounting the Loop Handle
:
Place the clamp (5) in the loop
handle (1) and fit handle in position
on the drive tube (6).
:
Fit the clamp (7).
:
Line up the holes.
:
Fit washers (8) on the screws (9)
and insert screws through the holes.
:
Screw on the square nuts (10) as far
as stop.
16
A
Aligning the Loop Handle
:
Adjust the loop handle (1) to the
most comfortable position for the
user and application.
Distance A must not be more than
22" (55 cm).
About 14" (35 cm) is recommended.
:
Tighten down screws on loop
handle firmly.
Fitting Carrying Eye*
(Clamp)
1
2
:
For position of carrying eye (clamp)*
see "Mounting the Loop Handle".
:
Position the clamp (1) so that the
tapped hole is on the left-hand side
of the drive tube (viewed from
powerhead).
:
Squeeze the ends of the clamp
together and hold it that position.
:
Insert M 6 x 14 screw (2).
:
Line up the carrying eye.
:
Tighten down the screw.
*
see "Guide to Using this Manual"
1
1
KB, KW
Capítulos
Tabla de contenido
