Backlight - Brandson Equipment 302316 Manual Del Usuario

5 Commissioning and Initial Settings
Switching on the device and the laser
Press for a long time to switch off the device. Alternatively, the device
switches to the standby mode if it is not used for 3 minutes.
"Clear/Power Off" button, stops the last action or empties the current dis
play content.
5.1 Measurement reference
The position of the measurement reference edge of the device (see figure below)
can be adjusted as desired. You can set the desired reference point using the
"Measurement reference" button (
Two different beeps indicate the corresponding set measurement point. Restarting
the device resets the set measurement reference point to the standard setting.

5.2 Backlight

The backlight is automatically switched on when the device is switched on. If the
device is not used for about 30 seconds, the backlight switches off. You can press
any button to switch it on again. Alternatively, the backlight can be switched on or
off with a long press of the "measurement reference" button.
40
).
English