I A; Storage On Site; Installation - Positioning The Unit; Installation Procedure - Mitsubishi Electric CLIMAVENETA i-LIFE2 SLIM 080 Manual De Instalación - Uso - Mantenimiento

STORAGE ON SITE

The units must be stored indoors!

INSTALLATION - POSITIONING THE UNIT

Avoid installing the unit:
- in places exposed to direct sunlight;
- near sources of heat;
- in damp environments and areas where there may be
contact with water;
- in environments with oil vapour;
- in environments with high frequency interference.
Make sure:
- the wall where the unit is installed features a suitable
structure and capacity;
- there are no pipes or wiring in the part of the wall affect-
ed;

INSTALLATION PROCEDURE

The following descriptions of the various assembly opera-
tions and the corresponding drawings refer to versions of
the unit with the fittings on the left.
The descriptions of assembly operations for units with the
fittings on the right are identical.
Only the drawings will need to be inverted horizontally.

MINIMUM INSTALLATION CLEARANCE

The figure illustrates the minimum clearance to be left from
walls and furniture in the room when assembling the fan coil.
- the wall where the unit is installed is perfectly flat;
- there is sufficient clearance around the unit to allow
proper air circulation at the intake and outlet;
- the wall where the unit is installed should be an outside
perimeter wall, so as to be able to drain the conden-
sate outside;
- in the event of ceiling installation (DLMO or DLIU ver-
sion), the air flow must not be aimed directly towards
people in the room.
For best installation results and optimum operating perfor-
mance, carefully observe the instructions provided in this
booklet.
Failure to heed the instructions may cause the equipment to
malfunction. In such cases, the warranty will be void and the
company declines all liability for any damage caused to peo-
ple, animals or things.
EN 05/2013 i-LIFE2 SLIM

I A

I A
I A
I A
9