Installation Instructions; Unpack The Refrigerator - Kitchen Aid Stainless Serie Guia De Instalacion

Installation Dimensions (Option 1)
1. Measure the distance from point A (as shown) to the back
wall. Add 1/16" (1.6 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than 11/32" (8.7 mm) thick, route the front
edge to allow the side panel to fit into the trim.
A
Installation Dimensions (Option 2)
1. Measure the distance from point A (as shown) to back wall.
2. Route the front edge of the support board or attach a
3/8" (9.5 mm) board to hold the panel in the cabinet side trim.
A
14
INSTALLATION
INSTRUCTIONS

Unpack the Refrigerator

WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
Do not remove the film covering until the refrigerator is in its
■
operating location.
All four leveling legs must contact the floor to support and
■
stabilize the full weight of the refrigerator.
Keep the cardboard shipping piece or plywood under the
■
refrigerator until it is installed in the operating location.
1. Remove and save the literature package bag taped to the side
of the refrigerator and the parts bag behind the grille. Remove
the four brackets (two on each side) that attach the shipping
base to the refrigerator bottom.
NOTE: Do not remove tape and door bracing until the
refrigerator is in its final location.
2. If necessary, reduce the tipping radius. See "Tipping Radius"
for ceiling height requirements or "Reduce Tipping Radius"
for step-by-step instructions. If you do not need to reduce the
tipping radius, proceed to "Move the Refrigerator into House."