Thetford Tecma EasyFit Premium Plus Manual Del Propietário página 6

Installation, con't.
Connect Electrical
Mount Tank Sensors
Full Tank Sensor / Mid Tank Sensor (Optional)
■ Clean the surface of the side of the tank at the top – approximately
on the left-right centerline with isopropyl alchohol (not included)
where the Full Tank Sensor will be mounted. When thoroughly clean
and dry, fi rmly press the sensor in place.
Wires can point in any direction – the sen-
NOTICE
sors directional orientation does not affect its
operation.
■ Follow the same procedure for the Mid Tank Sensor, except it should
be mounted on the left-right centerline approximately half way up the
tank side.
■ The Full Tank Sensor is mounted at the highest point on the tank minus
one inch (to allow for a few additional fl ushes) for the tank's capacity,
or where the installer wants the Tank Full indication to be.
■ The Tank Sensors should be mounted near the center line of the tank.
A7.1
A7.2
Keep wires away from sensor pads to avoid
NOTICE
false readings.)
A7.1
A7.2
Refer to Fig. A, C, G and Fig. H for references.
Ref. Description
A7.1 Full Tank Sensor - The sensor has a removable cover over the
pressure-sensitive adhesive pad.
A7.2 Mid Tank Sensor (Optional) - The sensor has a removable
cover over the pressure-sensitive adhesive pad.
C6 The area for adhesion should be thoroughly cleaned with alco-
hol or equivalent, and dried, prior to mounting the sensor.
98229 Rev. A (07.28.17)
C.6
Holding Tank Centerline
C.6
Fig. G
Tecma EasyFit Premium Plus RV Owner's & Installation Manual
6