Overriding Schedules Permanently; Auto Changeover - Honeywell Home RTH7600 Serie Manual Del Propietário

Program schedule override (permanent)
Press or to adjust
s t
temperature, then press HOLD. This
will turn off the program schedule.
Whatever temperature you set will
be maintained 24 hours a day, until
you manually change it, or press
USE SCHEDULE to cancel "Hold" and
resume the program schedule.

Auto changeover

Use this feature in climates where both air conditioning and heating are
used on the same day. When the system mode is in Auto, the thermostat
automatically selects heating or cooling depending on the indoor
temperature.
While in the Auto mode, if a schedule override takes place (temporarily
or permanently) the thermostat will automatically adjust the cooling and
heating settings to maintain a
3-degree separation between the
cool and heat settings.
For example, if the heat temperature
is raised to where it gets within
3-degrees of the cool setting, the
display will show an up arrow next
to "Cool" to show the thermostat
is raising the cool setting up to
maintain a 3-degree separation.
The display will also show both "Auto" and either "Heat" or "Cool" for which
temperature setting you are currently adjusting. Press the system button to
select between the heat and cool to view/adjust either mode.
CAUTION: To avoid possible compressor damage, do not use Auto
Changeover if the outside temperature drops below 50°F (10°C).
Mon
62
System
Fan Auto
Heat
Tue
69
º
System Auto Fan Auto
Heat
System
16
Temporary
Set To
68
6 : 08
AM
Permanent Hold
Hold
Cancel
Temporary
Set To
74
1 : 09
PM
Heat
Cool
Hold Cancel
M27533
M27534