Product Specifications; Typical Installation; Wiring Diagram; Quick Connector Instructions - HAMPTON BAY 7136-01 Guía De Uso Y Cuidado

Sistema de ventilación detector de humedad
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Product Specification
SPECIFICATIONS
Airflow: 140 CFM
120 V, 60 Hz
Duct diameter: 6 in.
Sound output: 1.0 Sones

Typical Installation

The ducting from this fan to the outside of the
building has a strong effect on the air flow, noise and
energy use of the fan. Use the shortest, straightest
duct routing possible for best performance, and
avoid installing the fan with smaller ducts than
recommended. Insulation around the ducts can
reduce energy loss and inhibit mold growth. Fans
installed with existing ducts may not achieve
their rated air flow.

Wiring Diagram

Power consumption: 48 W
Weight: 10.78 lbs.
Ceiling Opening Dimension Requirements: 10-13/16 in. (L) x 10-1/2 in.
(W) x 8-1/2 in. (H)
Properly insulate
around fan to
minimize building
heat loss and gain
Fan housing
Seal any gap around
fan housing
WARNING: Wiring must comply with all applicable electrical
codes. Turn OFF power before removing or installing connectors
WARNING: COPPER TO COPPER ONLY. Do not use Aluminum wire.
CAUTION: Accessory part (quick connector) should meet
NOTE: The connector is reusable on solid wires of the same wire gage
or smaller. Do not reuse the connector on stranded wires
• Strip wires 3/8 in. - 1/2 in.
• Grip the wire firmly and push
the stripped end of the wire into
the open port of the connector.
Use only one conductor
per port.
• Verify the stripped end of the
wires is fully inserted to the
back of the connector.
NOTE: Important wire information. Maximum temperature rating 105˚C
(221˚F). 600 volts maximum for building wire and 1000 volts maximum
for building wire and 1000 volts maximum in signs and lighting fixtures.
The acceptable wire range includes: Solid: 12-18 AWG.
3
SPECIFICATIONS
duct helps alignment
and absorbs sound
2-3 foot straight run
before elbow
House
wires
Please contact 1-855-HD-HAMPTON for further assistance.
Roof cap (with
built-in damper)
Caulk
termination
to duct
OR
Wall cap
(with
built-in
damper)
.
Quick
connect
Product
wires
HAMPTONBAY.COM

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1002-368-503

Tabla de contenido