Briteq COB BLINDER 2X 100W Manual De Instrucciones página 8

ENGLISH
• Use DOWN and UP buttons to selected the desired curve:
• Once you have the desired curve, press the ENTER button to save it.
Dimmer Speed
Used to set the speed (smoothness) of the dimmer continuously.
• Press the DOWN and UP buttons until the desired function is showing on the display.
• Press the [ENTER] button: the values can be changed
• Use DOWN and UP buttons to select the desired speed:
• 000 (0ms): The projector follows the instructions instantly, no delay (also called [LED behavior]).
...
• 255 (2000ms): The projector imitates the behavior of a halogen lamp (slower reaction time).
• Once the desired value shows on the display, press the [ENTER] button to confirm.
Remark: The default value (100 or 440ms) is the most realistic value to imitate "halogen lamp" behavior. At
the same time the light output will be instantaneous while pushing a flash button on your DMX-controller.
FAN SPEED
On some occasions fan noise should be reduced to a minimum. Therefore you can set 2 different fan
speed modes.
• Press the DOWN and UP buttons until the desired function is showing on the display.
• Press the [ENTER] button: the values can be changed
• Use DOWN and UP buttons to select one of these options:
• [Auto]: the fan speed will be automatically adjusted to always have the best balance between fan
noise and performance (light output). This is the best setting for use in theatres, conference rooms, ...
• [Low]: the fan speed will always be low to reduce fan noise to a minimum. However this means that
the LED temperature could become too high: in that case the LED current will be reduced
automatically to protect the LED. Light output will also be lower.
• Press the [ENTER] button to confirm.
LOCKING MODE
Used to lock the setup menu against unwanted altering of the settings.
• Press the MODE button until the desired function is showing on the display.
• Press the ENTER button: the values can be changed
• Use DOWN and UP buttons to select the desired mode:
• OFF
The setup menu can be used at any time.
• ON
After a short time the setup menu locks automatically, the display shows " LOCKED ***** ".
Unlock the display by pressing the buttons in this order: UP, DOWN, UP, DOWN, ENTER.
• Once the correct option shows on the display, press the ENTER button to save it.
NO DMX BEHAVIOR
Used to set how the projector reacts when the DMX-signal suddenly disappears.
• Press the MODE button until the desired function is showing on the display.
• Press the ENTER button: the values can be changed
• Use DOWN and UP buttons to select the desired mode:
• BLACKOUT
• FREEZE:
• Once the correct option shows on the display, press the ENTER button to save it.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.
FIRMWARE VERSION
Used to show the current version of the firmware.
• Press the MODE button until the FIRMWARE is showing on the display.
BRITEQ
®
output turns black while no DMX is detected.
output based on the last valid DMX-signal is kept on the projector.
6/44
USER MANUAL
COB BLINDER 2X100W