Assembly; Grass Box - Fitting / Removing - FLORABEST FSM R1 Instrucciones De Utilización Y De Seguridad

J
Check before use that the cutting edge is not
blunt and that its mounting is not damaged. Re-
place blunt or damaged cutting tools in a com-
plete set so as not to create a dynamic
unbalance.
J
Check the grass box
wear or deformation.
J
Regularly check all nuts and screws for their
tightness, to ensure a faultless operating condi-
tion for the appliance.
J
Avoid all collisions between the appliance and
foreign objects (e.g. branches, stones, metal
parts and toys)! Check the grassed area over
and remove all foreign objects!
J
Adjust the cutting height of the appliance such
that thecurved blade bar
tact with the ground (unevenness)!
J
In the event of a collision with a foreign object
or unusual vibrations, check the appliance for
possible damage and, if need be, arrange for
it to be repaired.
J
Never use the appliance with damaged protec-
tive fittings or coverings or deficient protective
equipments such as deflective or grass box
components.
J
For collecting the clippings, use the grass box
exclusively !
10
J
Only exchange damaged or worn parts for
original spare parts!
J
Only use replacement cutting tools of the same
type as those fitted into the appliance.
J
Switch the lawn mower off and remove the
plug when you transport it, cross areas other
than grass or bring the appliance from or to an
area to be mown.
Commissioning
Q

Assembly

Q
c Danger!
J
Carry out the assembly ONLY with the appliance
switched off and separated from the power supply!
J
Avoid causing damage to the power cable
e.g. through squashing it!
regularly for signs of
10
cannot make con-
21
6
General safety advice /Commissioning
Tip!
Lift the appliance from its packaging together
with a second person.
Fasten the steering shaft to the appliance.
j
Attach the power cable strain relief
lower shaft .
9
j
Place a retaining screw cover
the tube ends of the lower shaft handle
see Fig. A.
j
Insert the tube ends of the lower shaft
the two holes in the housing
j
Screw them down tightly with the two retaining
screws .
15
j
Now push the the retaining screw covers
over each of the retaining screws.
j
Fasten the upper shaft
connecting screws
j
Secure the power cable
to the upper
20 2
Fig. C).
Assembling the
10
j
Exactly fit the 2 grass box lower components
together with the grass box upper component.
Begin with the lower components.
The fasteners snap in clearly.

Grass box - fitting / removing

Q
c Danger!
J
Switch the appliance off! Wait until the curved
blade bar comes to a complete stop!
21
Fitting
j
Raise up the impact protection flap
j
Attach the grass box
ment devices and fit it into the clippings
18
ejection shaft (see Fig. B).
19
j
Lay the impact protection flap
grass box .
10
to the
7
on to each of
17
,
9
into
9
(see Fig. A).
14
17
with the help of both
2
to the lower shaft
8 9
with both cable clips
6
and lower shafts (see
9
grass box
.
11
to the upper attach-
10
onto the
11
GB/MT
.
35