Black and Decker Price Pfister Parisa 534 Serie Manual Del Usuario página 4

12
12C
12A
12 PULLOUT HOSE CONNECTION
From underneath sink, push Quick Connect Housing (12A), located on the end
of the Pullout Hose (12B) fi rmly upward onto Receiving Tube (12C), until unable
to push any further. Pull down on Quick Connect Housing (12A). If the housing
and Inner Collet (12D) separate slightly but do not pull off, the Receiving Tube
(12C) quick connect is secure.
13
13A
13D
13B
13C
13 WATER SUPPLY LINES
Gently separate hot and cold supply tubes (13A), approximately three inches
apart. Connect water Supply Lines (13C) to Faucet Inlets (13B). Hot water
supply line goes to hot inlet fi tting indicated by red tag (13D). (Supply lines
and fi ttings are not included.) Please follow manufacturer's instructions when
installing supply lines.
14
14B
14 SECURING INLET LINES
Do not cross Pullout Hose Connection (14A) with Inlet Supply Tubes (14B) to avoid
binding, jamming and interference with the movement of the pullout hose.
12D
12C
12A
12B
12A
13A
13B
13C
14B
14A
ENGLISH
15
15 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the
sink.
16
16 FLUSHING
To prevent damage to the internal parts of your faucet from debris that may
have collected in the water lines, it will be necessary to fl ush the faucet. Lift
the faucet handle (16A) up to the full on position. Run water for one minute.
Repeat in hot and cold positions.
17
17A
17A
17 SPRAY HEAD INSTALLATION
Assemble Sprayhead (17A) to Pullout Hose (17B) by turning the metal Hose
Fitting (17C) clockwise.
Caution: do not over tighten!
4
16A
17C
17B
17C