Cleaning The Torch Neck - Abicor Binzel ABIROB A Instructivo De Servicio

10 Troubleshooting
5 Place the retaining sleeve (1) inverted by 180° onto the new spiral liner (6) (side without
thread).
6 Cut off the overlapping spiral liner (6) flush with the retaining sleeve (1).
7 Screw the collet (5) onto the spiral liner (6) as far as it will go.
Use the sight bore on the collet (5) to check the position of the wire guide.
8 Slide the collet (5) and spiral liner (6) into the central connector (2) as far as they will go.
9 Screw the threaded side of the retaining sleeve (1) into the central connector (2) and
tighten.
10Use the nut (3) to secure the cable assembly (4) to the central connector (2).

9.3 Cleaning the torch neck

To increase the system availability of the welding robot, ABICOR BINZEL offers automated
torch cleaning.
1 Remove the gas nozzle.
2 Remove the weld spatter and spray with ABICOR BINZEL anti-spatter fluid.
3 Check the wear parts for visible damage and replace them if necessary.
4 Replace the equipment kit when worn or soiled.
5 Clean the separating point and O-rings with silicone-free seal grease.
6 Check the TCP after each use or after a collision in the WH alignment jig.
10 Troubleshooting
DANGER
Risk of injury and device damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
Please observe the attached 'Warranty' document. In the event of any doubts and/or problems,
please contact your retailer or the manufacturer.
NOTICE
• Consult the documentation for the welding components.
EN - 18
®
ABIROB
BAL.0125 • 2019-04-15
A