THERMOHEAT RMC-KFA75TL Manual Del Usuario E Instrucciones Para El Funcionamiento página 6

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
2. ASSEMBLY
For RMC-KFA75TL Model only
Tools Required
• Medium Phillips Screwdriver.
1. Assembling Handle & Cord Wrap
1) Lift front guard for arrow direction and make
sure that guard's wedged portion fits into the slit
hole on the upper housing.
2) Align the holes in the upper housing with ttwo
mounting holes on the handle as shown in Figure 6.
3) Secure handel with Screws with provided.
4) Insert card wrap into the rectangle holes on the
supportor and align the hole on the cord wrap with
the mounting hole on the side cover as shown in
Figure 6.
5) Secure cord wrap with Screws with provided.
2. Assembling BTU Control Valve.
1) Align slit hole on body of Valve with Tab on the
End Filter Cover as shown in figure 7.
2) Insert hooked leg of valve fully into slot of End
Filter Cover so that hooked leg is completely
locked to Slot.
NOTE : When install valve to End Filter Cover, If valve
is assembled for incorrect knob direction, Hooked leg is
not completely locked to slot.
Tools Required
• Medium Phillips Screwdriver.
• 19 Socket Wrench
1. Assembling Handle & Wheel and Cord Wrap
1) Slide axle through wheel support frame.
Install wheel bushings and wheels on axle
NOTE : When installing wheels, tube valve should face
out from support frame (Figure 8.)
2) Attach Cap Nuts on axle ends and tighten with
Socket Wrench.
3) Place heater on wheel support frame. Align the
holes on fuel tank flange with holes on wheel
support frame.
4) Position the Handles on top of fuel tank flange. Insert screws through handles, fuel tank flange and
wheel support frames as shown in Figure 8 and attach nut finger tight after each screw is inserted.
5) Align the hole on the handles with the mounging hole on the Cord Wrap.
Insert Screws through Cord Wrap, handles and attach nut finger tight after each screw is inserted.
6) After all screws are inserted, tighten nuts firmly.
Handle
Suppotor
Figure 6. Assembling Handle & Cord Wrap
BTU Control Valve
End Filter Cover
Slit Hole
Tab
Hooked Leg
Slot
Figure 7. Assembling BTU Control Valve
5
Screw
Frong Guard
Wedged Portion
Slit Hole
Cord Wrap
Side Cover
Screw
Knob direction when install
valve to End Filter Cover.
correct
Incorrect