Description; Installation - golmar IT-4N Manual De Instalación

48
D
escription of the interface.
D
escription of the operation LEDs.
Green LED
On: Divert mode enabled.
Off: Divert mode disabled.
Red LED
On: Power on.
Blinking : Programming mode.
Off: Power off.
D
etail of the interface's installation.
The interface can be installed on a DIN guide (10
elements) by gently pressing it in. To extract the interface
from the DIN guide, use a plain screwdriver to lever the
flange as shown in the picture.
f3,5 x 45
Connection block
Operation LEDs
DIN rail latch release
f3,5 x 45
To install the interface directly on the wall, drill two holes of
4 N
-
I T
Install the interface in a dry, protected place.
The operation LEDs are beside the
configuration dip switch.
Ø6mm. and insert the wallplugs. Fix the interface
with the specified screws.

DESCRIPTION

INSTALLATION

DIN 46277