Tabla de contenido
Idiomas disponibles
Idiomas disponibles
11. Slowly bring the pusher head (J) down to the blade assembly (T). If there
is contact, the pusher head may need to be adjusted. To adjust, loosen
the locking collar set screws (I) and position then adjust the pusher head
fingers. Tighten the locking collar set screws.
12. Lubricate the
pusher head pivot rod
each use. Do not use cooking oil as it will become sticky and may
permanently damage the equipment.
Lettuce King IV:
1. Familiarize yourself with the parts diagram for your equipment.
See Figure 7 (Spare Parts for Lettuce King IV) for parts to reference for
this procedure.
2. Allow ample room to work on a flat, dry surface.
3. Raise the handle and pusher head as far up as it will go.
4. Remove the screws retaining the blade assemblies (CC) and (DD).
Carefully remove and dispose the blade assemblies.
5. Examine the pusher head (K). If they are nicked or burred, smooth the
rough edges with a small flat file.
6. Verify that blade shields (BB) are installed on the blade assembly (CC)
and (DD).
7. Place the lower blade assembly (CC) into the frame (H) so the it is
positioned correctly and the sharp side up.
t
rouBleShooting
If the equipment no longer processes food cleanly or without damage to the food product, the blades could be dull and be in need of replacement. Broken, bent,
or nicked blades must be replaced.
Problem
It might be caused by
Broken Blade.
Blades were dull.
with mineral oil or Petro Gel after
8. Install the screws into the left side of the blade assembly (CC). Tighten
until contact is made with the frame (H). Turn the screw until tight, do not
exceed 1/2 turn or 40 in. lbs.
9. Place rubber washer between the right side frame (H) and the blade
assembly (CC). Insert the screws through the frame, and rubber washer
into the blade assembly. Turn the screw until tight, do not exceed 1/2 turn
or 40 in. lbs.
10. Place the upper blade assembly (DD) into the frame (H) so the it is
positioned correctly and the sharp side up.
11. Install the screws into the front side of the blade assembly (DD). Tighten
until contact is made with the frame (H). Turn the screw until tight, do not
exceed 1/2 turn or 40 in. lbs.
12. Place rubber washer between the back side frame (H) and the blade
assembly (DD). Insert the screws through the frame, and rubber washer
into the blade assembly. Turn the screw until tight, do not exceed 1/2 turn
or 40 in. lbs.
13. Slowly bring the pusher head down to the blades.
14. Lubricate the main frame guide rods with mineral oil or Petro Gel after
each use. Do not use cooking oil as it will become sticky and may
permanently damage the equipment.
Course of Action
Pre-score whenever possible to avoid undue shock and stress to blades.
Replace the blade assembly.
O
'
M
peratOr
s
anual
5
Tabla de contenido
