Troubleshooting - RIDGID DMG9015 Manual Del Operador

MAINTENANCE
This tool has been designed to be a low-maintenance tool. However, in order to maintain its performance, you must al-
ways follow these simple directions.
• A void exposing the tool to shock, continuous vibration, or extreme hot or cold temperature.
• S tore the tool indoors and in a safe place.
• A lways clean the tool with a clean, soft cloth. If necessary, slightly moisten the cloth with pure alcohol or a little water.
• C heck the batteries regularly to avoid deterioration. Always remove the batteries from the tool if it is not going to be used
for an extended period of time.
• R eplace the batteries when the battery icon displayed on the screen indicates that they are fully depleted:"
• D o not attempt to change any part of the unit.
• T ool service must be performed only by qualified Repair Center. Service or maintenance performed by unqualified per-
sonnel could result a risk of injury.

TROUBLESHOOTING

TROUBLE
The LCD screen will not turn
on.
The LCD display does not
operate correctly.
Inaccurate cutting angle or tilt
setting.
PROBABLE CAUSE
Batteries are installed incorrectly.
Battery voltage is low.
The LCD screen is damaged
Batteries are depleted.
The digital miter gauge was not calibrat-
ed to your table saw.
SOLUTION
Reinstall batteries with correct polarity.
Replace with new batteries when the empty
battery icon appears on LCD.
Take tool to the Service Center.
Replace with new batteries.
Ensure that your miter gauge has been cali-
brated to the table saw prior to use
13
".