Briggs & Stratton Snapper 7800968-01 Manual Del Operador página 29

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

equipment used for primary power in place of utility power or
on equipment used in life support applications. This warranty
does not include used, reconditioned, second-hand, or
demonstration equipment or engines. This warranty also
excludes failures due to acts of God and other force majeure
events beyond the manufacturer's control.
Briggs & Stratton Emissions Warranty
California, U.S. EPA, and Briggs & Stratton Corporation
Emissions Control Warranty - Your Warranty Rights and
Obligations
For Briggs & Stratton Engine Models with "F" Trim
Designation (Model-Type-Trim Representation xxxxxx
xxxx Fx) 
The California Air Resources Board, U.S. EPA, and Briggs
& Stratton (B&S) are pleased to explain the exhaust
and evaporative emissions ("emissions") control system
warranty on your 2019-2021 engine/equipment. In California,
new equipment that use small off-road engines must be
designed, built, and equipped to meet the State's stringent
anti-smog standards.  B&S must warrant the emissions
control system on your engine/equipment for the periods of
time listed below provided there has been no abuse, neglect
or improper maintenance of your small off-road engine or
equipment leading to the failure of the emissions control
system.
Your emissions control system may include parts such as
the carburetor or fuel-injection system, the ignition system,
catalytic converter, fuel tanks, fuel lines (for liquid fuel and
fuel vapors), fuel caps, valves, canisters, filters, clamps and
other associated components.  Also included may be hoses,
belts, connectors, and other emission-related assemblies.
Where a warrantable condition exists, B&S will repair your
engine/equipment at no cost to you including diagnosis,
parts, and labor. 
Manufacturer's Warranty Coverage:  
The exhaust and evaporative emissions control system
on your engine/equipment is warranted for two years.  If
any emissions-related part on your engine/equipment is
defective, the part will be repaired or replaced by B&S. 
Owner's Warranty Responsibilities: 
• As the engine/equipment owner, you are responsible
for the performance of the required maintenance listed
in your owner's manual.  B&S recommends that you
retain all receipts covering maintenance on your engine/
equipment, but B&S cannot deny warranty coverage
solely for the lack of receipts or for your failure to ensure
the performance of all scheduled maintenance. 
• As the engine/equipment owner, you should however
be aware that B&S may deny you warranty coverage
if your engine/equipment or a part has failed due to
abuse, neglect, or improper maintenance or unapproved
modifications. 
• You are responsible for presenting your engine/
equipment to a B&S distribution center or service
center as soon as the problem exists. The warranty
repairs shall be completed in a reasonable amount of
time, not to exceed 30 days. If you have a question
regarding your warranty rights and responsibilities you
should contact B&S at 1-800-444-7774 (in USA) or
BRIGGSandSTRATTON.COM. 
Briggs & Stratton Emissions Control Warranty
Provisions
The following are specific provisions relative to your
Emissions Control Warranty Coverage. It is in addition to the
B&S engine warranty for non-regulated engines found in the
Operator's Manual. 
1. Warranted Emissions Parts
Coverage under this warranty extends only to the parts
listed below (the emissions control systems parts) to the
extent these parts were present on the B&S engine and/
or B&S supplied fuel system. 
a. Fuel Metering System
• Cold start enrichment system (soft choke) 
• Carburetor or fuel injection system 
• Oxygen sensor 
• Electronic control unit 
• Fuel pump module 
• Fuel line (for liquid fuel and fuel vapors), fuel line
fittings, clamps 
• Fuel tank, cap and tether 
• Carbon canister and mounting bracket 
• Pressure relief valves
• Liquid/Vapor separator
b. Air Induction System
• Air cleaner 
• Intake manifold 
• Purge and vent line 
c. Ignition System
• Spark plug(s) 
• Magneto ignition system 
d. Catalyst System
• Catalytic converter 
• Exhaust manifold 
• Air injection system or pulse value 
e. Miscellaneous Items Used in Above Systems
• Vacuum, temperature, position, time sensitive
valves and switches 
• Connectors and assemblies 
• Electronic controls
2. Length of Coverage
Coverage is for a period of two years from the date of
delivery to an ultimate purchaser, or for the time period
listed in the respective engine or product warranty
statement, whichever is greater. B&S warrants to the
original purchaser and each subsequent purchaser
that the engine is designed, built, and equipped so as
to conform with all applicable regulations adopted by
the Air Resources Board; that it is free from defects in
29
Tabla de contenido
loading

Este manual también es adecuado para:

Snapper 7800968a-00

Tabla de contenido