Maintenance Schedule; Technical Service - Campbell Hausfeld VT639100 Manual De Instrucciones Y Lista De Piezas

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Operating Instructions and Parts Manual

Maintenance (Continued)

6. Check belt for signs of excessive wear. If belt shows signs of

wear, replace it. Check belt for proper tension / alignment.

To adjust belt:

a. Remove belt guard.

b. Remove belt.

c. Loosen the four fasteners holding the motor to the

baseplate.

d. Shift the motor in the proper direction. Tighten the four

fasteners holding motor to baseplate. The belt must be

properly aligned when adjustment is made.

e. To align belt, lay a straightedge against the face of the

flywheel touching the rim at two places (See Figure 19).

f. Adjust flywheel or motor pulley so that the belt runs

parallel to the straightedge (See Figure 19).

g. If necessary, use a gear puller to move the pulley on the

motor shaft. Tighten setscrew after pulley is positioned.

h. Reattach belt.

i. Reattach belt guard.

7. Change oil.

a. Allow compressor to run and warm up oil. Turn pressure

switch to the OFF position. Disconnect compressor from

main power by removing plug from outlet or shutting

off power at circuit breaker.

b. Position a pan under pump end of unit.

c. Remove oil drain plug (location shown in Figure 16).

Allow oil to collect in pan.

d. Replace drain plug. Fill pump to full level (See Figure 15)

using compressor oil listed on Oil Information chart.

TECHNICAL SERVICE

For information regarding the operation or repair of this

product, please call 1-800-543-6400.

www.campbellhausfeld.com

Touch Rim In

Two Places

Figure 19