Installing Your Radio - Insignia NS-C3111 Guia Del Usuario

Installing your radio

Precautions
• Choose the mounting location carefully so that the car stereo
will not interfere with the normal driving.
• Avoid installing the car stereo where it would be subject to high
temperatures, such as from direct sunlight or hot air from the
heater, or where it would be subject to dust, dirt, or excessive
vibration.
• Use only the supplied mounting hardware for a safe, secure
installation.
• Make sure that you remove the front panel before installing the
car stereo. (See "To detach the front panel:" on page 8.)
Adjusting the mounting angle
Adjust the mounting angle to less than 20° from the vertical. If the
angle is greater than 20°, the front panel will not open.
Installing the car stereo
To install the car stereo:
1 Remove and discard the two shipping screws from the top of the
stereo.
2 Insert the release keys into the sides of the mounting bracket until
they stop, then slide the car stereo out of the mounting bracket.
Note
3 Find or make a 7.17 × 2.09 inch (182 × 53 mm) rectangular
opening in your dashboard.
4 Insert the mounting bracket into the opening, then use a
screwdriver to bend enough of the bracket mounting tabs to
secure the mounting bracket into the opening.
4
Keep the release keys in a safe place, because you may need them
later to remove the car stereo from the car.
www.insignia-products.com
NS-C3111 Car Stereo CD/MP3 Player
Shipping screws