LiftMaster ART200K Manual Del Usario página 17

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
GATE TYPES
The location of the motor installation depends on the type of gate.
If the gate stop is on the floor the motor should also be installed as
low as possible in order for the gate not to be distorted. Only use
frame elements for fastening.With steel gates the fittings should be
fastened to the main frame. If you are not sure about the stability of
the frame in question then reinforce it.
With wooden gates the frame has to be drilled through
completelywhere the fittings are to be fastened. Attaching a plate
from the outside is recommended in order to prevent fastening from
becoming loose. Thin wooden gates must be reinforced additionally
as they do not withstand the strain otherwise.
Max gate width/weight
Max gate height
Specifications calculated without windload
GATE CONFIGURATION
The ART is suitable for use with wide pillars, up to about 30cm in width. The amount of room around the pier affects the opening angle and the
position of the arms.
105°
GATE STOPS
A SWING GATE NEEDS A FIXED GATE STOP IN BOTH THE OPEN AND
CLOSE POSITIONS. Gate stops save wear and tear on the motor, gate and
fittings. Operating a gate without fixed limit stops results in poor performance. It is
often dangerous, leads to premature wear and voids your warranty!
2,5m per wing / 150Kg
2,0m per wing / 200Kg
1,5m per wing / 250Kg
1,5m
C
105°
2
A
C
E
B=60-70cm
7-8 cm = 90°
=
max. 10 cm
ca.
90
90
0
B
D
F
90
o
o
90
0
Tabla de contenido
loading

Tabla de contenido